Is there anyone use Mellanox FDR14 active optical cable on QDR switch?
I used this combination on old Voltaire 4036 QDR switch without any problems.
I have a plan to migration to FDR fabric that cause to purchase FDR14 active optical cables previously.
I'm also configure my Mellanox MIS 5035 switch with this command.
switch-628bc4 [standalone: master] > enable
switch-628bc4 [standalone: master] # configure terminal
switch-628bc4 [standalone: master] (config) # activate cable enable
SM was configure properly.
But symbol errors were cretaed in random sequence and ports!
Is there any configuration needed?