Hi,
I'm using an LC\LC fibre cable. The SFP in the card is an MLX.MFM1T02A-SR (part number I have on invoice) and the SFP on the Cisco side is a Cisco module - the part number of which I do not have to hand.
OFED self test shows the cards as not connected.
# hca_self_test.ofed
---- Performing Adapter Device Self Test ----
Number of CAs Detected ................. 1
PCI Device Check ....................... PASS
Kernel Arch ............................ x86_64
Host Driver Version .................... MLNX_OFED_LINUX-2.3-2.0.0 (OFED-2.3-2.0.0): 2.6.32-504.el6.x86_64
Host Driver RPM Check .................. PASS
Firmware on CA #0 NIC .................. v2.32.5100
Firmware Check on CA #0 (NIC) .......... PASS
Host Driver Initialization ............. PASS
Number of CA Ports Active .............. 0
Port State of Port #1 on CA #0 (NIC)..... DOWN (Ethernet)
Port State of Port #2 on CA #0 (NIC)..... DOWN (Ethernet)
Error Counter Check on CA #0 (NIC)...... NA (Eth ports)
Kernel Syslog Check .................... PASS
Node GUID on CA #0 (NIC) ............... <removed>
------------------ DONE ---------------------
I'm just trying to figure our where in the chain things are not as they should be...