Hello,
in three computers I have three dual port 10 Gb NICs ConnectX-2. I would like to upgrade their firmwares. I followed instruction how to identify correct adapter on: http://www.mellanox.com/page/firmware_HCA_FW_identification
I got these results:
C:\Program Files\Mellanox\WinMFT>mst status
MST devices:
------------
mt26448_pci_cr0
mt26448_pciconf0
C:\Program Files\Mellanox\WinMFT>flint -d /dev/mst/mt26448_pci_cr0 query
Image type: FS2
FW Version: 2.7.8200
Rom Info: type=PXE version=1.5.6 devid=26448 proto=ETH
Device ID: 26448
Description: Port1 Port2
VSD:
PSID: IBM0DB0000010
C:\Program Files\Mellanox\WinMFT>flint -d /dev/mst/mt26448_pciconf0 query
Image type: FS2
FW Version: 2.7.8200
Rom Info: type=PXE version=1.5.6 devid=26448 proto=ETH
Device ID: 26448
Description: Port1 Port2
VSD:
PSID: IBM0DB0000010
The problem is that PSID is not in the format "MT_".
I checked a list of firmwares on http://www.mellanox.com/page/firmware_table_ConnectX2EN and I am not sure what is the correct.
Can anyone give me advice please?
I suppose I have MNPH29C-XTR because I found photo of a card on eBay (looks same as my card) and the card is described as MNPH29C-XTR.
And the second question please:
When I type "mst status" then I got two devices. Should I run update for both of them?
flint -d <First device> -I <binary image> burn
flint -d <Second device> -I <binary image> burn
Thank you.
Rick Penic